So i have made a mould using instant mould of efgt scenery for my goblins bases, i have pressed the gs into the mould and i dont know whether i have to leave it in the mould to harden for 24 hours or if i can take it out after a 5 minute pressing period and the gs wont just lose the detail, sinking back to a useless pice of hard gs. thanks in advance!

Unless you're using a lot of lubricant I certainly would recommend taking it out of the mold before at least about 2 hours pass.

_________________
'Though my memory's fading, I remember two things very clearly: I am a great sinner and Christ is a great Savior'
-John Newton

ok, good thing i took mine out i was just worried the detail would sink awy, thanks as always Sid!

Be sure to post a picture of the cast! It sounds very interesting!

_________________
Over the field rang his clear voice calling: "Death! Ride, ride to ruin and the world's ending!"

Will do once I start a WIP

You shouldn't need to use any lubricant if it is instant mold you are using.
The details in Green stuff will certainly soften more the sooner you remove it, but if it is only planks then you probably wont notice too much.

_________________
You don't have to be great to start. But you do have to start to be great.

As ukfb said - shouldn't need lubricant and taking it out before it is set might ruin some of the detail.

_________________
My trade thread
http://www.one-ring.co.uk/viewtopic.php?f=38&t=25957&p=325932#p325932

Oh I see... I thought you said GS... my bad heheh

_________________
'Though my memory's fading, I remember two things very clearly: I am a great sinner and Christ is a great Savior'
-John Newton

Haven't used any lubricant and details look great taken progress pics but in no means a tutorial as it may seem...