Quote:
How did you do the water effect? I'm thinking of making a small lake sometime and I like the look of that. Please tell
I am still working on the pool . It will take lot of small steps to make it turn out well. I think it will be a good time to review what I have done so far. I am using a product called EnviroTex Lite
pour-on High Gloss Finish. I use it for special application on furniture. You must carefully follow the manufactures directions to avoid air bubbles. It take as much as 72 hours to fully cure. It is really tough and can be sanded. It is safe with Styrofoam and paper. It has been my experience that care should be taken to avoid trapping moisture under the clear coat. Make sure all of the paint and glue on the project is completely dry before you pour.
Step one is make your plain and choose your materialsI used 1/4 inch Hardwood and 1/2 inch MDFB. I marked out the MDFB and cut it with a jig saw set at 45 degrees. I used Carpenter glue to laminate the hardwood sheet to the MDFB. Make a note of the glue bead and the clamps.This is important to prevent warps and leaks. Leaks will cause trapped air bubbles.I let it dry over night.
The next step is to form the bed and texture and seal it.I used water based materials so it was possible to do most of it at the same times. I used wood filler carpenters glue and sand for texture.I added brown paint to the glue. When every thing was dry. I dry brushed it. I painted the center of the pool black and blended dark green around the edge.
The next step is to start adding the detail that needs to be embedded.I glued down the larger stones first. I painted on a layer of PVA the added the medium and then the fine sand. I used the brush to sweep the sand into shape. After it dried over night, I poured the first layer of resin.
The next step will be to add some layers of flocking.I will cover that in the next post