Quote:
the paints I use are from P3 and Vallejo mostly so the names of the colours won't mean much to most people I suspect. I'll try to translate them into the nearest GW equivalent.
I undercoat the whole thing in white, then base coat the bricks with Graveyard Earth and, while that is still wet, mix in a little Khaki or Bleached Bone on the stones themselves.
Leave that to dry and then drybrush a range of lighter shades of brown and grey over selected stones. And then use a wash of GW's Devlin Mud over the whole thing, concentrating on the joints between the stones.
Then I drybrush and highlight again. And finally, on a few stones, I use a very thin wash of Bleached Bone to give a subtle variation of the colour of the stones.
The plaster is a blend of two colours that have no real equivalent in GW's range, so I'll use their P3 names: Moldy Ochre and Menoth White Highlight. The 'white' is tinted slightly yellow and gives the whole thing an aged look. If you use khaki or other 'brownish' tints, the plaster comes out looking pink (not DayGlo, but bad enough).
I should probably invest in the Vallejo range as a number of people here use it, and tend to prefer them. I googled P3 and found Menoth White but I couldn't see a set with Moldy Ochre in.
Thanks for the thorough reply, the brickwork still amazes me, I still can't understand how you got those results
The texture of the polyfilla just adds the realism of stonework. Now that you mention it, I can see an orangey yellow glow in the plaster, which I may have to consider when I come to paint mine.
Quote:
Hope that helps
Certainly did, thanks again