The One Ring
http://wwww.one-ring.co.uk/

testors dull coat
http://wwww.one-ring.co.uk/viewtopic.php?f=30&t=17794
Page 1 of 1

Author:  1egolas [ Sat Mar 13, 2010 11:23 pm ]
Post subject:  testors dull coat

ive heard that testors is the most matt finished varnish you can buy so i wanna get some. i just wondered if anyone has any advice on using it???
do you apply it straight over the model it after a coat of purity seal etc?
do you paint it on or is it best to use a spray gun?
and if you do use a spray gun would it work with the citadel one?
thanks in advance
1egolas

Author:  El Rabbito [ Sun Mar 14, 2010 12:19 am ]
Post subject: 

Just stir and shake well and brush it on...no need for purity seal, dull coat will do the same job only much much better.I wouldn't bother with spraying it..you'll lose a fair amount of it that way..just pick a mid size brush and away you go.

Author:  Gandlaf the Grey [ Wed Mar 17, 2010 8:54 pm ]
Post subject: 

It is a case of what paints you are using.

Testors can 'eat' away at inks so beware.

I've had a couple of goes and I am settling on a coat of Purity seal then two coats of testors.
On my Merry article I was still in the experimental phase and it didn't really work, but if you check my WIP thread I have used the above method on my 'dead' figures and as you can see the stuff is flawless.

Good luck, though it can be a bit tough to come by. I found some by continually checking Antenociti Workshop and struck lucky one night so I ordered a couple to keep me going.

Author:  captain krak [ Wed Mar 17, 2010 9:27 pm ]
Post subject: 

I have been using testors over a coat of gloss and it has worked well sprayed. Does anyone have experience with the Citadel matt varnish spray can?

Author:  1egolas [ Thu Mar 18, 2010 12:53 pm ]
Post subject: 

ive seen the matt varnish cans before on forums and guides and things but ive never actually seen it in gw or on their webstore is it oop or something.
i have used vallejo matt varnish spray and that works pretty well but its quite easy to put too much on and that gives a satin finish so im prefering to paint varnishes on now

Page 1 of 1 All times are UTC
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/